pin change interrupt arduino mega 2560 code

The traditional AVR processors have a limited number of 'real hardware interrupt' pins, each associated with their own ISR vector and thus routine. I now realise that indeed the differences in reaction time are caused by the differences in the 'interrupt architecture'. Use PF2 as output pin for the logic analyserĪttachInterrupt(digitalPinToInterrupt(InputSignalPin), test_interrupt, FALLING ) Īny idea what might cause this very long time between the time the interrupt signal appears, and the moment the ISR becomes active on the new Arduino Nano Every?įirst thanks for your reactions. I wrote the following test code: #define InputSignalPin 19 // INT2 om the Mega 2560 - PF3 on the Nano Every

The input signal that triggers the interrupt is in both cases identical. I made a test setup with an Arduino Mega 2560 and an Arduino Nano Every. On the classical Arduino's it takes less than one microsec ( when compiling with board: 'Arduino Mega or Mega 2560'), but on the Every it takes between 6 microseconds ( when compiling with MegaCoreX an board: 'ATMega 4809 / Pinout: Nano Every') or even 8 microseconds ( when compiling with board: 'Arduino Nano Every' / Registers Emulation: None'). However I noticed on my logic analyser quite a difference between the times interrups are raised and the ISR is entered.

I have a bigger program moved from the traditional Arduino's (UNO, MEGA) to the Nano Every (4809).

Pin change interrupt arduino mega 2560 code